Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U1331    Software Incompatibility with Body Control Module "B"

for Preparation Click here


DESCRIPTION

This DTC is stored when the destination information of the main body ECU does not match the destination information stored in the blind spot monitor sensor.

DTC Code
DTC Detection Condition
Trouble Area
U1331
Destination information of the main body ECU and blind spot monitor sensor do not match.
  1. Main body ECU (cowl side junction block LH)
  2. Blind spot monitor sensor RH
  3. Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CONFIRM PART NUMBER (MAIN BODY ECU)
  1. Check the main body ECU part number.

    1. Check if the part number of the main body ECU on the vehicle is correct.

      OK:
      The parts number is correct.



NG
REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
OK


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.
    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor RH
    B
    DTC is output from the blind spot monitor sensor LH
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)