Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > Turn Signal Switch Circuit

for Preparation Click here


DESCRIPTION

The blind spot monitor sensor receives a turn signal light information signal from the headlight dimmer switch assembly.

WIRING DIAGRAM


E231113E01


INSPECTION PROCEDURE

NOTICE:
Before performing the inspection, check that there are no problems related to the Lighting system.

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Blind Spot Monitor Master or Blind Spot Monitor Slave / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Blind Spot Monitor Master 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Master Side Turn Signal
    State of the master side turn signal / OFF or ON
    ON: Right turn signal received
    OFF: Right turn signal not received
    -

    Blind Spot Monitor Slave 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Slave Side Turn Switch
    State of the slave side turn signal / OFF or ON
    ON: Left turn signal received
    OFF: Left turn signal not received
    -
    Result 
    Result
    Proceed to
    The display changes as shown above when the right turn switch or left turn switch is operated.
    A
    The display does not change as shown above when the right turn switch is operated.
    B
    The display does not change as shown above when the left turn switch is operated.
    C



B
Go to step 2

C
Go to step 3
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - HEADLIGHT DIMMER SWITCH ASSEMBLY)
  1. Disconnect the P25 blind spot monitor sensor RH connector.

  1. Disconnect the H11 headlight dimmer switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P25-2 (BSTR) - H11-13 (TR)
    Always
    Below 1 Ω
    P25-2 (BSTR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)  

3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - HEADLIGHT DIMMER SWITCH ASSEMBLY)
  1. Disconnect the O46 blind spot monitor sensor LH connector.

  1. Disconnect the H11 headlight dimmer switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O46-2 (BSTL) - H11-15 (TL)
    Always
    Below 1 Ω
    O46-2 (BSTL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)