DTC U0232 Lost Communication with Blind Spot Monitor Slave Module |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0232 | There is no communication from the blind spot monitor sensor LH. |
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and CAN branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (BLIND SPOT MONITOR SENSOR LH CAN BRANCH WIRE) |
![]() |
Disconnect the O46 blind spot monitor sensor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O46-8 (CA1P) - O46-4 (CA1N) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Blind Spot Monitor Sensor LH) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O46-5 (BLB) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O46-1 (BLGD) - Body ground | Always | Below 1 Ω |
| O46-3 (LGND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Blind Spot Monitor Sensor LH) |
|
| ||||
| OK | ||
| ||