CAN COMMUNICATION SYSTEM > Gateway ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Gateway ECU Communication Stop Mode | Either condition is met:
|
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and CAN branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (NETWORK GATEWAY ECU CAN BRANCH WIRE)) |
![]() |
Disconnect the H120 network gateway ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H120-16 (CA1H) - H120-15 (CA1L) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Network Gateway ECU) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (NETWORK GATEWAY ECU - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H120-2 (BATT) - Body ground | Always | 11 to 14 V |
| H120-10 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| H120-9 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H120-4 (GND) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Network Gateway ECU) |
|
| ||||
| OK | ||
| ||