Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > Security Indicator Light Does not Blink

for Preparation Click here


DESCRIPTION

The transponder key ECU assembly blinks the security indicator light when the immobiliser is set.

WIRING DIAGRAM


B271007E47


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, refer to Service Bulletin.
  2. When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

1.PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Immobiliser / Active Test.

  1. Perform the Active Test according to the display on the GTS.

    Immobiliser 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON/OFF
    -

    OK:
    Security indicator light can be turned on and off using the GTS.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY 

2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - ACCESSORY METER ASSEMBLY)
  1. Disconnect the H32 transponder key ECU assembly connector.

  1. Disconnect the I22 accessory meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-8 (IND) - I22-17 (LP)
    Always
    Below 1 Ω
    H32-8 (IND) - Body ground
    Always
    10 kΩ or higher
    I22-17 (LP) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TRANSPONDER KEY ECU ASSEMBLY (TERMINAL IND)


    C279117E01
  1. Disconnect the I22 accessory meter assembly connector.

  1. Connect the H32 transponder key ECU assembly connector.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Accessory Meter Assembly)

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I22-17 (LP) - Body ground
    Key not in ignition key cylinder
    Pulse generation
    Key in ignition key cylinder
    Below 1 V



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

REPLACE ACCESSORY METER ASSEMBLY (SECURITY INDICATOR LIGHT) (Click here)