For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Back door hinge installation hole | φ12 (0.47) |
| B, b | Quarter panel reinforcement corner | - |
| C, c | Quarter panel standard hole | φ13 (0.51) |
| D, d | Back door damper stay installation nut | M8 (0.31) |
| E, e | Back door side stopper installation nut | M6 (0.24) |
| F, f | Rear floor panel extension standard hole | φ15 (0.59) |
| G, g | Back door rock striker installation nut | M8 (0.31) |
| H, h | Rear floor pan standard hole | φ30 (1.18) |
| I, i | Center body pillar assembly mark | - |
| *a | Vehicle Dimensions | *b | mm
(in.) |