Home › Vehicle Exterior › BODY WELD POINT › ROOF PANEL(for Sliding Roof) › 2015.08–2016.10
BM27L0U _01 Vehicle Exterior _049510 BODY WELD POINT _0237205 ROOF PANEL(for Sliding Roof) F

BODY WELD POINT  ROOF PANEL(for Sliding Roof)  ASSEMBLY REPLACEMENT  


K127287

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points

REMOVAL POINT
1.

If reusing the roof panel reinforcement, trim the hemming location using a disc sander, etc.


K127340C01
0.531,5.094 0.948,4.615 false 0.396,5.115 0.708,5.333 0.313,0.219 10 false *a
*a Disc Sander - -



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108825

Plug Weld
K108834

Body Sealer

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After the roof panel reinforcement is welded to the new parts, install the roof panel to the vehicle side.

4.

Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel reinforcement and back door opening frame.

HINT:

Apply just enough body sealer for the new parts to make contact.


5.

After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

6.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

7.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K127341C01
0.729,4.99 0.729,4.385 false 2.76,4.563 3.177,4.365 false 0.656,4.177 0.969,4.333 0.313,0.156 10 false *a 3.198,4.229 3.51,4.385 0.313,0.156 10 false *b
*a Wooden Hammer *b Cloth Tape