Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS
BM27L0U _V1 General _049512 INTRODUCTION _0249517 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED



Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed
Power back door system initialization To initialize, close the back door completely by hand.

NOTICE:

w/ Navigation System:

After the ignition switch is turned off, the navigation receiver assembly requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.