Refer to the TOYOTA Repair Manual for each work procedure.
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part | Necessary Procedures | Effects / Inoperative Functions When Necessary Procedures are not Performed |
|---|---|---|
| ECM | Register VIN | DTC P0630 is output |
·
Throttle body assembly ·
Cleaning the deposits from the throttle body assembly ·
Engine assembly ·
Cylinder head sub-assembly ·
Camshaft (for intake or exhaust camshaft) ·
Camshaft timing gear assembly ·
Camshaft timing exhaust gear assembly ·
Piston or piston ring ·
Mass air flow meter sub-assembly ·
Fuel injector assembly ·
Fuel pump ·
Air fuel ratio sensor ·
Heated oxygen sensor ·
Engine coolant temperature sensor ·
Spark plug Ignition coil assembly ·
Air leaks from air induction system ·
Gas leaks from exhaust system ·
Knock sensor |
Inspection after repair | Poor idle, engine starting, etc. |
for 3UR-FBE:
Fuel with different alcohol concentration is used |
Reset fuel density learning value | ·
Engine starting ·
Rough idling |
| Distance control ECU | Initialize distance control ECU | Dynamic radar cruise control system |
·
Automatic transmission assembly ·
Valve body assembly ·
Any of the shift solenoid valves |
Reset memory | Large shift shock |
| Automatic transmission fluid | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. |
| Tire pressure warning ECU | 1.
Register transmitter IDs 2.
Initialize tire pressure warning system |
·
When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates ·
Tire pressure monitoring function |
| Tire pressure warning valve and transmitter | 1.
Register transmitter IDs 2.
Initialize tire pressure warning system |
·
When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates ·
Tire pressure monitoring function of replaced wheel |
| Suspension control ECU | Registration | Air suspension system |
| Skid control ECU | ·
Deceleration sensor zero point calibration ·
Master cylinder pressure sensor zero point calibration |
·
ABS warning light illumination ·
Slip indicator light illumination |
| Yaw rate sensor | ·
Zero point calibration data clearance ·
Deceleration sensor zero point calibration |
·
ABS warning light illumination ·
Slip indicator light illumination ·
VSC control is prohibited or operation is incorrect |
| Front Wheel Alignment Adjustment | ·
Zero point calibration data clearance ·
Deceleration sensor zero point calibration ·
Perform initialization of steering angle sensor |
VSC control is prohibited or operation is incorrect |
| Occupant classification ECU | ·
Zero point calibration ·
Sensitivity check |
·
Occupant classification system ·
Passenger airbag ON/OFF indicator ·
Airbag system (Front passenger side) ·
Seat belt warning system (Front passenger side) |
·
Transponder key ECU ·
ECM ·
Key |
Registration | Engine starting |
·
Door control transmitter ·
Door control receiver |
Register recognition code | Wireless door lock operation |
| Inner rear view mirror | Compass calibration
·
Compass calibration ·
Register transmitter code |
Direction is not displayed correctly
·
Direction is not displayed correctly ·
Garage door opener system |
| Inner rear view mirror (Garage door opener transmitter) | Register transmitter code | Garage door opener system |
·
Power window regulator motor (for Driver Side) ·
Power window regulator motor (for Passenger Side) ·
Back door power window regulator motor |
Initialize the motor | ·
Jam protection function ·
Power window control system |
·
Sliding roof drive gear (Sliding roof ECU) ·
Sliding roof housing ·
Sliding roof glass |
Initialize sliding roof system | ·
Auto operation ·
Jam protection function ·
Sliding roof operation after ignition switch is turned OFF ·
Key-linked operation function (Driver side door only) |