Upper Face
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | No. 1 body mounting hole | φ26 (1.02) |
| B, b | Front spring support hole - outer | φ12.2 (0.480) |
| C, c | No. 2 body mounting hole | φ43 (1.69) |
| D, d | Side rail inner channel standard hole | 30X20 (1.18X0.79) |
| E, e | No. 4 body mounting hole | φ43 (1.69) |
| F, f | No. 6 body mounting hole | φ43 (1.69) |
| *A | RH | *B | LH |
| *C | Front | - | - |
| *a | Imaginary Datum Line | *b | Wheel base |
| *c | mm
(in.) |
- | - |
Lower Face
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Front bumper reinforcement installation bolt | M10 (0.39) |
| B, b | Front stabilizer bracket installation nut | M12 (0.47) |
| C, c | Suspension lower arm installation hole - rear | 42X24 (1.65X0.94) |
| D, d | Suspension lower arm installation hole - front | 36.5X18.5 (1.437X0.728) |
| E, e | Side rail inner channel standard hole | 16X16 (0.63X0.63) |
| F, f | Suspension upper arm installation hole - rear | φ19.5 (0.768) |
| G, g | Rear suspension member installation hole | φ28 (1.10) |
| H, h | Rear shock absorber installation hole | φ14.5 (0.571) |
| I, i | Rear suspension member installation hole | φ32 (1.26) |
| J, j | Transport hook installation nut | φ18 (0.71) |
| *A | RH | *B | LH |
| *C | Front | - | - |
| *a | Imaginary Datum Line | *b | Wheel base |
| *c | mm
(in.) |
- | - |