General
The cooling system uses a pressurized forced circulation system with open air type reservoir tank.
An engine coolant distribution pathway is provided between the left and right banks of the cylinder block.
A thermostat with a bypass valve is located on the plastic water inlet to maintain suitable temperature distribution in the cooling system.
An aluminum radiator core is used for weight reduction.
A 2-stage temperature-controlled coupling fan is used. It rotates at lower speeds when the engine is cold to minimize fan noise.
TOYOTA genuine Super Long Life Coolant (SLLC) is used as the engine coolant.
| *A | Optional Equipment | - | - |
| *1 | Throttle Body | *2 | Thermostat |
| *3 | Radiator | *4 | Water Pump |
| *5 | Oil Cooler | - | - |
| *a | To Heater Radiator | *b | From Heater Radiator |
| *A | Optional Equipment | - | - |
| *1 | Radiator Reservoir Tank | *2 | Throttle Body |
| *3 | Radiator | *4 | Water Pump |
| *5 | Thermostat | *6 | Cylinder Block |
| *7 | Cylinder Block Water Jacket Spacer | *8 | Water Jacket |
| *9 | Oil Cooler | *10 | Cylinder Head |
| *11 | Heater Radiator | *12 | Transmission Oil Cooler (Warmer) |
| *13 | Engine Coolant Distribution Pathway | - | - |
|
SLLC is pre-mixed (the U.S.A. models: 50 % coolant and 50 % deionized water, the Canada models: 55 % coolant and 45 % deionized water). Therefore, no dilution is needed when SLLC in the vehicle is added or replaced. |
|||
| Engine Coolant | Type | TOYOTA Genuine Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids.) Do not use plain water alone. | |
| Capacity | without Oil Cooler | 13.7 Liters (14.5 US qts, 12.0 Imp. qts) | |
| with Oil Cooler | 14.6 Liters (15.4 US qts, 12.8 Imp. qts) | ||
| Color | Pink | ||
| Maintenance Intervals | First time | 100,000 mile (160,000 km) | |
| Subsequent | Every 50,000 mile (80,000 km) | ||
| Thermostat | Opening Temperature | 80°C to 84°F (176°C to 183°F) | |
Water Pump
A rust-resistant water pump rotor made of stainless steel is used.
The water pump circulates the engine coolant to the engine coolant distribution pathway located between the left and right banks of the cylinder block.
| *1 | Water Pump Gasket | *2 | Water Pump |
| *3 | Timing Chain Cover | *4 | Rotor |
| *a | From Water Inlet Housing | *b | View from Back Side |
Engine Coolant Distribution Pathway
The water pump circulates the engine coolant and directs it to the engine coolant distribution pathway located between the left and right banks. From there, the engine coolant is uniformly distributed to each cylinder of the cylinder block, and also directly discharged to the cylinder heads. As a result, the cooling performance of the cylinder heads is assured and reliability is improved.
| *1 | Heat Exchanger Cover | *2 | Engine Coolant Distribution Pathway |
| *3 | Cylinder Block | - | - |
| *a | From Water Pump | *b | To Cylinder Head |
| *c | Front Side | *d | Engine Coolant Flow |