Home › General › CHASSIS › AB60E / AB60F AUTOMATIC TRANSMISSION
NM27L0U _V1 General _050239 CHASSIS _0242396 AB60E / AB60F AUTOMATIC TRANSMISSION UN GENERAL/CONTROL/DETAILS F

CHASSIS  AB60E / AB60F AUTOMATIC TRANSMISSION  GENERAL/CONTROL/DETAILS  ATF FILLING PROCEDURE  


ATF FILLING PROCEDURE


a.

An ATF filling procedure is used in order to improve the accuracy of the ATF level when the transmission is being repaired or replaced. As a result, the oil filler tube and the oil level gauge used in the conventional automatic transmission have been discontinued, eliminating the need to inspect the fluid level as a part of routine maintenance.

i.

This filling procedure uses a refill plug, overflow plug, ATF temperature sensor No. 2, and shift position indicator light "D".


ii.

ATF filling procedures are different between the models with an ATF cooler and the models without an ATF cooler.

AB60E Automatic Transmission
X128165C01
1.271,3.333 1.271,2.875 true 4.479,3.313 4.198,2.833 true 1.25,1.604 1.5,1.823 0.25,0.219 10 false *1 4.469,3.313 4.719,3.531 0.25,0.219 10 false *2 1.208,3.323 1.458,3.542 0.25,0.219 10 false *a
*1 Refill Plug *2 Overflow Plug
*a Proper Level in ATF Filling Mode - -


AB60F Automatic Transmission
X130695C01
4.438,3.219 4.24,2.688 true 1.521,3.26 1.375,2.729 true 4.417,3.24 4.729,3.438 0.313,0.198 10 false *2 1.49,3.292 1.802,3.49 0.313,0.198 10 false *a 1.302,1.479 1.615,1.677 0.313,0.198 10 false *1
*1 Refill Plug *2 Overflow Plug
*a Proper Level in ATF Filling Mode - -


HINT:

For details about the ATF filling procedures, see the Repair Manual.