Home › General › CHASSIS › PROPELLER SHAFT AND DRIVE SHAFT
NM27L0U _V1 General _050239 CHASSIS _0242397 PROPELLER SHAFT AND DRIVE SHAFT UN GENERAL/CONTROL/DETAILS F

CHASSIS  PROPELLER SHAFT AND DRIVE SHAFT  GENERAL/CONTROL/DETAILS  DRIVE SHAFT  


DESCRIPTION


a.

The front drive shafts for 4WD models use the double offset type CVJ (Constant Velocity Joint) on the differential side, and the Rzeppa type CVJ on the wheel side. Both the right and left have the same length to ensure straightline stability.

X130689C02
2.375,0.76 2.375,0.333 true 4.646,0.76 4.646,0.313 true 2.302,0.115 2.656,0.375 0.354,0.26 10 false *1 0.573,0.865 0.906,1.115 0.333,0.25 10 false *a 4.563,0.135 4.917,0.396 0.354,0.26 10 false *2 6.26,0.875 6.615,1.135 0.354,0.26 10 false *b
*1 Double Offset Type CVJ *2 Rzeppa Type CVJ
*a Front Differential Side *b Wheel Side



b.

The rear drive shafts for all models use the double offset type CVJ (Constant Velocity Joint) on the differential side, and the Rzeppa type CVJ on the wheel side.

X128209C02
2.292,1.073 1.896,0.531 true 4.813,1.063 5.271,0.51 true 5.021,2.698 5.438,2.281 true 2.313,2.719 2.01,2.188 true 5.281,0.25 5.594,0.448 0.313,0.198 10 false *2 1.74,0.271 2.052,0.469 0.313,0.198 10 false *1 3.427,1.792 3.74,1.99 0.313,0.198 10 false *c 6.365,1.146 6.677,1.344 0.313,0.198 10 false *b 0.604,1.156 0.917,1.354 0.313,0.198 10 false *a 1.833,1.927 2.146,2.125 0.313,0.198 10 false *2 0.594,2.823 0.906,3.021 0.313,0.198 10 false *b 5.417,2.052 5.729,2.25 0.313,0.198 10 false *1 6.406,2.792 6.719,2.99 0.313,0.198 10 false *a 3.51,3.365 4.219,3.552 0.708,0.188 10 false *d
*1 Rzeppa Type CVJ *2 Double Offset Type CVJ
*a Wheel Side *b Rear Differential Side
*c LH *d RH