Warning Function
The tire pressure warning ECU has 2 warning methods that are used, depending on the condition detected.
| Tire Pressure Warning Light | Detection Condition |
|---|---|
| Turns ON | The tire pressure warning ECU has detected that a tire inflation pressure becomes lower than the threshold. The threshold varies according to the initialization value. |
| Turns ON after blinking for 1 minute | The tire pressure warning ECU has detected a malfunction in the system. |
If the tire pressure warning light turned ON, adjust the tire inflation pressure.
If the warning light turns ON after blinking for 1 minute, it can be turned OFF by repairing the malfunction in the system.
The tire pressure warning light may blink for 1 minute and turn on due to electric wave interference at the same frequency.
Initial Check Function
After the ignition switch is tuned ON, the tire pressure warning ECU lights up the tire pressure warning light for 3 seconds to check the warning light circuits.
Initialization Function
The warning threshold is calculated from the tire inflation pressure and memorized in the tire pressure warning ECU. Therefore, the tire pressure warning ECU should be initialized after:
Specified value change of the tire inflation pressure according to the instruction of the weight or speed condition or different size of tire.
Tire rotation
Replacement of a tire pressure warning ECU or the tire pressure warning valve and transmitter.
The tire pressure warning ECU can be initialized as follows:
Set the tire inflation pressure for all tires to the specified value.
Keep the tire pressure warning reset switch pressed for three seconds or more with the ignition switch ON.
The tire pressure warning light blinks three times and the initialization mode starts.
The initialization is completed when signals from all the tire pressure warning valve and transmitters are received.
After the initialization has been completed, turn the IG OFF and then ON again, and check the pressure of all tires using the Techstream.
Turning the ignition switch OFF does not cancel the initialization mode.
Reset switch cannot operate while driving.
Diagnosis
If the tire pressure warning ECU detects a malfunction in the system, the tire pressure warning ECU will make the tire pressure warning light blink at 1Hz for 1 minute then remain on to warn the driver. It will also store the Diagnostic Trouble Codes (DTCs) in memory.
5-digit DTCs can be read by connecting a Techstream to the DLC3.
2-digit DTCs can be read by connecting the SST (09843-18040) to the TC and CG terminals of the DLC3 and monitoring the blinking of the tire pressure warning light.
The test mode can be selected using a Techstream that is connected to DLC3.
For details, see the Repair Manual.
| *1 | Tire Pressure Warning Light | - | - |