Home › General › BODY ELECTRICAL › MEMORY SYSTEM
NM27L0U _V1 General _050243 BODY ELECTRICAL _0243562 MEMORY SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  MEMORY SYSTEM  GENERAL/CONTROL/DETAILS  DESCRIPTION  


DESCRIPTION


a.

The memory system can store the position of the driver seat, outside rear view mirror, and tilt and telescopic. The positions for up to two different drivers can be stored in the system memory and recalled.

i.

The memory system is standard equipment on the Platinum grade and optional equipment on the Limited grade.


ii.

The positions for up to two different drivers can be saved using the memory switch.


iii.

The driver seat ECU stores the four recordable adjustments of the seat (seat slide, front vertical, rear vertical and recline position) in its memory. The driver seat ECU is built into the power seat switch for the driver seat.


iv.

The mirror ECU stores the outside rear view mirror position in its memory.


v.

The tilt and telescopic ECU stores the tilt & telescopic position in its memory.


vi.

The driver seat ECU outputs a signal to each ECU to reproduce a stored position.


vii.

The memory and recall conditions of this system are as follows.

Function Condition
Memory Memorizes the positions when all conditions below have been met and the button 1 or 2 is pushed while the "SET" button is pushed.
·

Ignition switch is ON.

·

Shift position is "P"


When the memory setting is completed, the buzzer in the power seat switch will sound for 0.5 seconds.
Recall If the button 1 or 2 is pressed when all conditions below have been met, it recalls the positions.
·

Ignition switch is ON.

·

Shift position is "P".


If the button 1 or 2 is pressed when all conditions below have been met, it recalls the positions within 30 seconds.
·

Ignition switch is OFF.

·

Driver door is opened.