Home › General › BODY ELECTRICAL › WIRELESS DOOR LOCK CONTROL SYSTEM
NM27L0U _V1 General _050243 BODY ELECTRICAL _0244359 WIRELESS DOOR LOCK CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  WIRELESS DOOR LOCK CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  FUNCTION  


GENERAL


a.

The wireless door lock control system has the following functions:

Function Outline

*: Models with power back door system

All Doors Lock Pressing the lock button on the transmitter locks all doors.
All Doors Unlock (2-step Unlock) Pressing the unlock button on the transmitter once unlocks the driver's door. If the unlock button is pushed again within 3 seconds, all doors unlock.
Automatic Lock If no door is opened for 60 seconds and the ignition key is not in the ignition key cylinder after unlocking the doors by pushing the unlock button on the transmitter, all doors are locked again automatically.
Answer Back Operation The hazard light flashes once when locking, and the hazard light flashes twice when unlocking, to inform that the operation has been completed.
The wireless door lock buzzer sounds once when locking, and the wireless door lock buzzer sounds twice when unlocking, to inform that the operation has been completed.
Panic Alarm Operation Pressing and holding the panic button on the transmitter for approximately 0.8 seconds activates alarms. Pushing any button on the transmitter during the alarms cancels the alarms.
Door Ajar Warning If any door is open or ajar, pressing the lock button of the transmitter will cause the wireless door lock buzzer to sound for about 10 seconds.
Power Back Door Open/Close* Keeping the power back door button of the key-integrated type transmitter pressed longer than about 1 second opens or closes the power back door.
Transmitter Recognition Code Registration
·

A maximum of 7 types of transmitter recognition codes can be registered in the door control receiver.

·

When 7 codes are already registered and a new code is registered, the oldest of the already registered codes is written over.


Customized Body Electronics For details, refer to the Repair Manual



TRANSMITTER RECOGNITION CODE REGISTRATION FUNCTION


a.

The table below shows the four types of the registration function modes for the special code ID through which up to 4 different codes can be registered. The codes are electronically registered (written and stored) in the EEPROM. For details of the recognition code registration procedure, refer to the Repair Manual.

Mode Function
Rewrite Mode Erases all previously registered codes and registers only the newly received codes.
Add Mode Adds a newly received code while preserving any previously registered codes. This mode is used when a new transmitter is added. If the number of codes exceeds 7, the oldest registered code is erased first.
Confirm Mode Confirms how many codes are currently registered. When a new code is added, this mode is used to check how many codes already exist.
Prohibit Mode Deletes all the registered codes and prohibits the wireless door lock function.This mode is used when the transmitter is lost.