DESCRIPTION
If a seat belt is not fastened, this system flashes the seat belt warning light and sounds the buzzer in the combination meter as a reminder.
The seat belt warning buzzer for the front passenger can be cancelled. However, the legally mandated minimum operation of the buzzer cannot be cancelled.
When the ignition switch is turned to the ON position, this system detects the condition of the seat belts based on the signals indicated below.
| Seat | Signal | Warning Method |
|---|---|---|
| Driver | Seat Belt Buckle Switch (Contact Type) | ·
Buzzer Sounds ·
Warning Light Flashes |
| Front Passenger | ·
Seat Belt Buckle Switch (Non-contact Type) ·
Four Occupant Classification Sensors (Though the Occupant Classification ECU) |
·
Buzzer Sounds ·
Warning Light Flashes |
Buzzer warning cancel mode can be set using a Techstream. For details, refer to the Repair Manual.