Home › General › BODY ELECTRICAL › BLIND SPOT MONITOR SYSTEM
NM27L0U _V1 General _050243 BODY ELECTRICAL _0244636 BLIND SPOT MONITOR SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  BLIND SPOT MONITOR SYSTEM  GENERAL/CONTROL/DETAILS  FUNCTION OF MAIN COMPONENTS  


FUNCTION OF MAIN COMPONENTS


Components Function
Blind Spot Monitor Sensors LH and RH
·

Radiate radar waves from the blind spot monitor sensor to the blind spot sensor detection area, use the reflected millimeter waves for detecting the presence of a vehicle, vehicle-to-vehicle distance and relative speed, and then transmit this information to the built-in signal processing circuit.

·

The signal processing circuit determines if a vehicle is present, and illuminates or blinks the blind spot monitor indicator accordingly.


Warning Cancel Switch Assembly Disables the blind spot monitor system operation when the switch is turned off.
Outer Rear View Mirror Assemblies LH and RH Blind Spot Monitor Indicator
·

Illuminates to inform the driver that a vehicle has been detected in the blind spot detection area.

·

Flashes to inform the driver when the turn signal switch is operated if a vehicle has been detected in the blind spot detection area.


Combination Meter Assembly Multi-information Display The combination meter assembly is provided with a multi-information display to inform the driver of malfunctions in the blind spot monitor system.
Steering Angle Sensor Transmits the steering angle signal to the blind spot monitor sensors LH and RH.
ECM Transmits the reverse signal to the blind spot monitor sensor LH and RH.
Skid Control ECU (ABS and Traction Actuator Assembly) Transmits the vehicle speed signal to the blind spot monitor sensor LH and RH.
Main Body ECU (Cowl Side Junction Block LH) Transmits the destination signal to the blind spot monitor sensors LH and RH.