PRECAUTIONS
The blind spot monitor system is not designed to detect the following types of vehicle and/or objects:
Vehicles that enter the detection area from the opposite direction.
Motorcycles, bicycles, pedestrians etc. that enter the detection area.*
Following vehicle that are in the same lane.*
Guardrails, walls, signs, parked vehicle and similar stationary objects that enter the detection area.*
Vehicles driving 2 lanes across from your vehicle that enter the detection area.*
*: Depending on conditions, unnecessary detection of a vehicle and/or object may occur.
The blind spot monitor system may not detect vehicles correctly in the following conditions:
During bad weather such as heavy rain, fog, snow etc.
When there is a significant difference in speed between your vehicle and the vehicle that enters the detection area.
When a vehicle is in the detection area from a stop and remains in the detection area as your vehicle accelerates.
If a vehicle enters the detection area when driving up or down consecutive steep inclines.
When driving on a road surface that is wet due to rain, previous rain, standing water etc.
When multiple vehicles approach with only a small gap between each vehicle.
When vehicle lanes are wide, and the vehicle in the next lane is too far away from your vehicle.
When the vehicle that enters the detection area is traveling at about the same speed as your vehicle.
When towing anything such as trailer, boat, etc.
The blind spot monitor system may detect a vehicle and/or object unnecessarily under the following conditions
When vehicle lanes are narrow and a vehicle driving 2 lanes across from your vehicle enters the detection area.
When on sharp bends and a following vehicle is present.
When under strong sunlight, the outside rear view mirror indicator may be difficult to see.
If a system malfunction is detected due to any of the following reasons, warning message appears on the multi-information display:
There is a malfunction with the sensors.
The sensors have become dirty.
The outside temperature is extremely high or low.
The sensor voltage has become abnormal.
The driver is solely responsible for safe driving. Always drive safely, taking care to observe your surroundings. The blind spot monitor system is a supplementary system which alerts the driver that a vehicle is present in the outside rear view mirror's blind spot. Do not overly rely on the blind spot monitor system. The system does not judge if it is safe to change lanes, therefore over reliance could cause an accident resulting in death or serious injury. According to conditions, the system may not function correctly. Therefore the driver's own visual confirmation of safety is necessary.There is 1 blind spot monitor sensor installed on the left and right side of the vehicle rear bumper respectively. Observe the following to ensure the blind spot monitor system can function correctly.
Keep the sensor and its surrounding area on the bumper clean at all times.
Do not subject the sensor or surrounding area on the bumper to a strong impact. If the sensor moves even slightly off position, the system may malfunction and vehicles that enter the detection area may not be detected. If the sensor or surrounding area is subject to a strong impact, always have the area inspected by your Toyota dealer.
Do not disassemble the sensor or its surrounding area on the bumper.
Do not attach accessories or stickers to the sensor or surrounding area on the bumper.
Do not modify the sensor or surrounding area on the bumper.
Do not paint the sensor or surrounding area on the bumper.
Do not paint the rear bumper any color other than an official TOYOTA color.
Do not apply strong impacts to the sensor or drop it, as it is a high-precision device.
Do not reuse a sensor that has been dropped or subjected to a strong impact.