Home › General › BODY ELECTRICAL › DYNAMIC LASER CRUISE CONTROL SYSTEM
NM27L0U _V1 General _050243 BODY ELECTRICAL _0249483 DYNAMIC LASER CRUISE CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  DYNAMIC LASER CRUISE CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  DESCRIPTION  


DESCRIPTION


a.

The dynamic laser cruise control system has two cruise control modes: Constant speed control mode, and vehicle-to-vehicle distance control mode.

i.

The cruise control switch is used for switching between the two modes. The mode in which the cruise control system starts is the vehicle-to-vehicle distance control mode.


ii.

The distance control ECU, laser radar sensor and ECM control this system.


iii.

The combination meter informs the driver of the control conditions.

Mode Outline
Constant Speed Control Mode The constant speed control mode is the same as in the cruise control system.
Vehicle-to-vehicle Distance Control Mode In the vehicle-to-vehicle distance control mode, the system recognizes and determines the lane in which the driver's own vehicle and the vehicle ahead are traveling. Thus, the system is able to maintain the proper vehicle-to-vehicle distance in accordance with the vehicle speed, and allows the vehicle to be driven under follow-up control.
·

The driver can operate the distance control switch on the steering wheel to select the vehicle-to-vehicle distance in three stages: long, middle, and short.

·

This mode consists mainly of four controls: constant speed control, deceleration control, follow-up control, and acceleration control.

·

The illustrations below show control examples while the driver's own vehicle is driving at 100 km/h (62 mph), and the vehicle ahead is driving at 80 km/h (50 mph).

·

Throttle control and brake control achieve smooth deceleration.



Y196154E01
0.323,0.542 1.438,1.24 1.115,0.698 10 false Constant Speed Control 2.115,0.542 2.958,1.302 0.844,0.76 10 false Deceleration Control 3.781,0.521 4.5,1.292 0.719,0.771 10 false Follow-up Control 5.531,0.5 7.01,0.813 1.479,0.313 10 false Aceleration Contorol 0.313,3.604 1.823,3.979 1.51,0.375 10 false 100 km/ h (62 mph) 1.969,3.583 3.302,4.427 1.333,0.844 10 false 100 km/h (62 mph)→ 80 km/h (50 mph) 3.771,3.583 5.031,4.01 1.26,0.427 10 false 80 km/ h (50 mph) 5.417,3.583 6.677,4.552 1.26,0.969 10 false 80 km/h (50 mph)→ 100 km/h (62 mph)

HINT:

When either the distance control ECU or the ECM is replaced, the laser radar sensor information stored in the replaced ECU must be initialized. For details, refer to the Repair Manual.



iv.

As in the cruise control system, the constant speed control mode is controlled by the ECM, which outputs signals to the actuators.

Y196155E01
3.333,0.854 3.844,1.219 0.51,0.365 10 false ECM 0.688,0.458 2.094,1.125 1.406,0.667 10 false Various Sensors and Switches 3.656,1.896 4.771,2.302 1.115,0.406 10 false CAN (V1 Bus) 5,1.344 6.479,1.688 1.479,0.344 10 false Throttle Control Motor 4.969,0.156 6.51,0.906 1.542,0.75 10 false Solenoid Valves for Automtic Transmission


v.

The vehicle-to-vehicle distance control mode is controlled by the laser radar sensor and distance control ECU. Thus, the signals are output to the actuators and the ECU while the data is being exchanged as indicated below.

Y196156E01
5.427,0.792 6.552,1.177 1.125,0.385 10 false CAN (V1 Bus) 4.615,0.25 6.094,0.635 1.479,0.385 10 false Distance Control ECU 1.177,0.271 2.531,0.646 1.354,0.375 10 false Laser Radar Sensor