General
Effective application of vibration damping and noise suppressant materials reduces engine, wind and road noises.
General
Foamed sound insulation materials have been optimally located in the cross section of the body frame parts.
| *a | A - A Cross Section | - | - |
|
Foamed Sound Insulation Materials | - | - |
To reduce the amount of road noise, engine noise, and droning sound that enter the cabin, a floor panel is coated with a vibration-damping material.
|
Vibration-damping Material | - | - |
A dash panel outer insulator is used for the dash panel of vehicles equipped with the 2UZ-FE engine to reduce cabin noise.
| *1 | Dash Panel Outer Insulator | *2 | Dash panel |
A headlining with an air barrier film layer is provided to reduce the amount of noise entering the cabin.
The insulation layer has been discontinued. Instead, a sound absorbing carpet containing an air controllable layer (bico layer) is provided to reduce the amount of noise entering the cabin.
Felt is provided on the back side of the trim and garnish to reduce the amount of noise entering the cabin.
| *1 | Headlining | *2 | Floor Carpet |
| *3 | Felt | - | - |
| *a | Floor Carpet Cross Section | *b | Headlining Cross Section |
| *c | Air Controllable Layer (Bico Layer) | *d | Air Barrier Film Layer |
The wiper arms and blades are positioned at the bottom of the windshield where they do not effect the flow of air, realizing a reduction in wind noise.
| *1 | Engine Hood | *2 | Wiper Arm |
| *3 | Windshield Glass | *4 | Wiper Blade |
|
Floor Carpet Cross Section | - | - |