Front Wiper
Smooth and smartly designed wiper arms and blades are used to highlight the body design.
The wiper blade distributes pressure more evenly throughout the blade. As a result, it improves wiping performance.
Two materials are used on the wiper blade. Highly durable EPDM (Ethylene Propylene Diene Monomer) synthetic rubber is used for the hinges, and natural rubber with excellent wiping performance is used for the blade tip.
The bonded graphite coating is refined. It is chemically bonded to the rubber, providing long-lasting low-friction performance.
An airfoil is integrated into the wiper element to help prevent the blades from lifting off the windshield.
The joint-less flat blades help maintain even pressure along the blades at low temperatures and in snowy and icy conditions.
The holes provided in the wiper arm ensure a smooth air flow and prevent the wiper from being lifted by the wind.
| *a | A - A Cross Section | *b | Hole |
| *c | Airfoil | *d | Bonded Graphite Coating |
| *e | Spline | - | - |
|
EPDM Synthetic Rubber |
|
Neutral Rubber Blade Tip |
Rear Wiper
A raised type wiper continues to be used, allowing the rear wiper to be stored at the tailgate position when not in use and rise to the specified height when in use. This enables the back door window to open and close smoothly when the wiper is not in use.
The wiper arm width is increased to express the bold design of a full-size SUV.
| *1 | Step Linear | *2 | Rear Wiper |
| *a | Rising Zone | *b | Wiping Angle (115 degrees) |
| *c | Wiper Blade Length (300 mm (11.8 in.)) | *d | Arm Width (31 mm (1.2 in.)) |