Home › General › SPECIFICATIONS › SUSPENSION CONTROL
RM27L0U _V1 General _049291 SPECIFICATIONS _0235484 SUSPENSION CONTROL F

SPECIFICATIONS  SUSPENSION CONTROL  SERVICE DATA  


Suspension Control System
Amount of change in vehicle height HIGH position: 30 mm (1.18 in.)
LOW position: 30 mm (1.18 in.)
Difference between the tester value and vehicle height
(C - D measurement):
5 mm (0.20 in.) or less
Difference between the right side and the left side 10 mm (0.39 in.) or less

Rear Height Control Sensor
Tester Connection Sensor Condition Specified Condition
for LH side
2 (SHRL) - 1 (SHG)
High (45°) 3.60 to 4.52 V
Normal (0°) 2.06 to 2.45 V
Low (-45°) 0.40 to 0.51 V
for RH side
2 (SHRR) - 1 (SHG)
High (45°) 3.60 to 4.52 V
Normal (0°) 2.06 to 2.45 V
Low (-45°) 0.40 to 0.51 V

Acceleration Sensor
Tester Connection Sensor Condition Specified Condition
for LH side
1 (SGRR) - 2 (SGND)
Sensor stationary Approx. 2.0 to 2.5 V
Sensor is tilted Change between approx. 0.9 to 2.3 V
for RH side
1 (SGFL) - 2 (SHG)
Sensor stationary Approx. 2.0 to 2.5 V
Sensor is tilted Change between approx. 0.9 to 2.3 V

Absorber Control Actuator
Tester Connection Sensor Condition Specified Condition
1 (FAL+) - 2 (FAL-) Always 6.4 to 7.2 Ω
3 (FBL-) - 4 (FBL+) Always 6.4 to 7.2 Ω
1 (FAR+) - 2 (FAR-) Always 6.4 to 7.2 Ω
3 (FBR-) - 4 (FBLR+) Always 6.4 to 7.2 Ω

Suspension Control Switch
Tester Connection Switch Condition Specified Condition
9 (ECU1) - 7 (GND) SPORT position Below 1 Ω
Normal position 10 kΩ or higher
8 (ECU2) - 7 (GND) COMFORT position Below 1 Ω
Normal position 10 kΩ or higher