Home › Engine / Hybrid System › 3UR-FBE ENGINE CONTROL › ACCELERATOR PEDAL
RM27L0U _51 Engine / Hybrid System _049293 3UR-FBE ENGINE CONTROL _0235520 ACCELERATOR PEDAL G

3UR-FBE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream main switch on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.


e.

Read the value displayed on the Techstream.

Standard Voltage:
Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
Released 0.5 to 1.1 V 1.2 to 2.0 V
Depressed 2.6 to 4.5 V 3.4 to 4.7 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.