Home › Engine / Hybrid System › 3UR-FBE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM27L0U _51 Engine / Hybrid System _049293 3UR-FBE ENGINE CONTROL _0235528 HEATED OXYGEN SENSOR A

3UR-FBE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the heated oxygen sensor (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

a.
A158663

Install the heated oxygen sensor to the front No. 2 exhaust pipe assembly by hand.


b.
A184940E03
0.917,0.542 1.031,0.542 1.031,0.542 1.333,0.854 true 2.719,0.052 3.385,0.573 0.667,0.521 10 true Fulcrum Length 0.604,0.479 0.896,0.792 0.292,0.313 10 true SST

Using SST, tighten the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.

·

Perform "Inspection After Repairs" after replacing the heated oxygen sensor (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).




c.

Connect the heated oxygen sensor connector and 2 clamps.


Hide 89465 2.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.
A158663

Install the heated oxygen sensor to the front exhaust pipe assembly by hand.


b.
A184942E03
1.063,0.125 1.26,0.125 1.26,0.125 1.531,0.344 true 2.802,0.333 3.385,1.177 0.583,0.844 10 true Fulcrum Length 0.729,0.052 1.052,0.354 0.323,0.302 10 true SST

Using SST, tighten the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.

·

Perform "Inspection After Repairs" after replacing the heated oxygen sensor (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).




c.

Connect the heated oxygen sensor connector.