Home › Engine / Hybrid System › 3UR-FBE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM27L0U _51 Engine / Hybrid System _049293 3UR-FBE ENGINE CONTROL _0235528 HEATED OXYGEN SENSOR G

3UR-FBE ENGINE CONTROL  HEATED OXYGEN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89465 1.CHECK HEATED OXYGEN SENSOR

a.

Disconnect the 2 sensor connectors.


b.
A380327E01
1.906,1.938 2.281,1.323 2.281,1.323 2.406,1.323 false 1.406,1.958 1.031,1.354 1.031,1.354 0.896,1.354 false 0.083,0.104 2.688,0.74 2.604,0.635 10 false Component without harness connected: (Heated Oxygen Sensor) 0.667,1.281 0.979,1.479 0.313,0.198 10 false +B 2.479,1.156 3.021,1.531 0.542,0.375 10 false HT1B*1 HT2B*2 0.219,2.542 1.073,2.844 0.854,0.302 10 false *1: for Bank 1 0.229,2.896 1.135,3.219 0.906,0.323 10 false *2: for Bank 2

Measure the heater resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B)
(for Bank 1)
20°C (68°F) 11 to 16 Ω
1 (HT2B) - 2 (+B)
(for Bank 2)


If the result is not as specified, replace the sensor.


c.

Connect the 2 sensor connectors.