Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM27L0U _51 Engine / Hybrid System _049294 3UR-FE ENGINE CONTROL _0235542 HEATED OXYGEN SENSOR A

3UR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the heated oxygen sensor (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

HINT:

Perform "Inspection After Repairs" after replacing the heated oxygen sensor (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).


a.
A158663

Install the heated oxygen sensor to the front No. 2 exhaust pipe assembly by hand.


b.
A184940E04
0.958,0.521 1.375,0.833 true 2.5,0.031 3.073,0.396 0.573,0.365 10 true Fulcrum Length 0.563,0.406 0.938,0.594 0.375,0.188 10 true SST

Using SST, tighten the heated oxygen sensor.

SST
09224-00010  

·

without SST


Torque:
44 N*m (449 kgf*cm, 32 ft.*lbf)

·

with SST


Torque:
40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




c.

Connect the heated oxygen sensor connector and 2 clamps.


Hide 89465 2.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

HINT:

Perform "Inspection After Repairs" after replacing the heated oxygen sensor (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).


a.
A158663

Install the heated oxygen sensor to the front exhaust pipe assembly by hand.


b.
A184942E04
1.073,0.146 1.531,0.344 false 2.792,0.375 3.385,1.021 0.594,0.646 10 true Fulcrum Length 0.688,0.052 1.073,0.26 0.385,0.208 10 true SST

Using SST, tighten the heated oxygen sensor.

SST
09224-00010  

·

without SST


Torque:
44 N*m (449 kgf*cm, 32 ft.*lbf)

·

with SST


Torque:
40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




c.

Connect the heated oxygen sensor connector.