Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM27L0U _51 Engine / Hybrid System _049294 3UR-FE ENGINE CONTROL _0235542 HEATED OXYGEN SENSOR G

3UR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89465 1.CHECK HEATED OXYGEN SENSOR

a.

Disconnect the 2 sensor connectors.


b.
A379741E01
1.875,1.875 2.188,1.448 2.188,1.448 2.344,1.448 true 1.344,1.896 1.167,1.458 1.167,1.458 0.99,1.458 true 0.208,0.156 2.677,0.5 2.469,0.344 10 false Component without harness connected: (Heated Oxygen Sensor) 2.406,1.25 2.979,1.427 0.573,0.177 10 false HT1B*1 2.406,1.427 2.979,1.604 0.573,0.177 10 false HT2B*2 0.729,1.365 1.01,1.563 0.281,0.198 10 false +B 0.156,2.656 1.146,2.854 0.99,0.198 10 false *1: for Bank 1 0.146,2.969 1.135,3.167 0.99,0.198 10 false *2: for Bank 2

Measure the heater resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B)
(for Bank 1)
20°C (68°F) 11 to 16 Ω
1 (HT2B) - 2 (+B)
(for Bank 2)


If the result is not as specified, replace the sensor.


c.

Connect the 2 sensor connectors.