Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM27L0U _51 Engine / Hybrid System _049294 3UR-FE ENGINE CONTROL _0235545 CAMSHAFT OIL CONTROL VALVE G

3UR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 15330B 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A165596E01
0.132,0.074 2.647,0.458 2.515,0.385 10 Component without harness connected: (Oil Control Valve)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the oil control valve assembly.


b.
A165597E06
2.667,0.969 2.844,1.135 false 3.063,1.135 3.188,0.979 false 2.688,2.771 3.188,2.969 0.5,0.198 10 false Battery 2.542,0.781 2.656,0.948 0.115,0.167 10 false 1 3.24,0.781 3.385,0.938 0.146,0.156 10 false 2 0.073,0.073 2.552,0.458 2.479,0.385 10 false Component without harness connected: (Oil Control Valve)

Connect the battery positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

OK:
Condition Specified Condition
Battery positive (+) voltage is applied Valve moves in left arrow direction shown in the illustration
Battery positive (+) voltage is cut off Valve moves in right arrow direction shown in the illustration


If the result is not as specified, replace the oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.