Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › SFI SYSTEM
RM27L0U _51 Engine / Hybrid System _049294 3UR-FE ENGINE CONTROL _0235547 SFI SYSTEM L

3UR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

Perform RESET MEMORY (AT initialization) for 2WD when replacing the automatic transmission assembly, engine assembly or ECM (See page Drivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).

·

Perform RESET MEMORY (AT initialization) for 4WD when replacing the automatic transmission assembly, engine assembly or ECM (See page Drivetrain>AB60F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION).

·

Perform REGISTRATION (VIN registration) when replacing the ECM (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION).



HINT:

RESET MEMORY cannot be completed by only removing the battery.



WHEN USING TECHSTREAM



CAUTION:

Observe the following items for safety reasons:

·

Read its instruction books before using the Techstream.

·

Prevent the Techstream cable from being caught on the pedals, shift lever and steering wheel when driving with the Techstream connected to the vehicle.

·

When driving the vehicle for testing purposes using the Techstream, 2 persons are required. One person drives the vehicle, and the other operates the Techstream.