Home › Engine / Hybrid System › 3UR-FBE ENGINE MECHANICAL › DRIVE BELT
RM27L0U _51 Engine / Hybrid System _049295 3UR-FBE ENGINE MECHANICAL _0235549 DRIVE BELT G

3UR-FBE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT FAN & GENERATOR V BELT

A163769E01
0.283,2.741 1.015,2.931 0.732,0.191 10 CORRECT 1.705,2.741 2.597,2.917 0.892,0.177 10 INCORRECT

a.

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.

Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the groove on the bottom to the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



Hide 16620 2.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

a.

Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise. If a malfunction exists, replace the tensioner.