Home › Engine / Hybrid System › 3UR-FBE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM27L0U _51 Engine / Hybrid System _049295 3UR-FBE ENGINE MECHANICAL _0235552 FRONT CRANKSHAFT OIL SEAL A

3UR-FBE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

a.

Remove the radiator assembly (See page Engine / Hybrid System>3UR-FBE COOLING>RADIATOR>REMOVAL).


Hide 48811 2.SEPARATE FRONT STABILIZER BAR

a.
A163772

Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes, separate the stabilizer bar.


Hide 13471 3.REMOVE CRANKSHAFT PULLEY

a.
A164228E08
0.188,0.948 0.188,1.896 false 0.188,1.896 0.354,1.333 false 0.052,1.938 0.375,2.125 0.323,0.188 10 false SST 1.167,2.604 1.51,2.781 0.344,0.177 10 false Turn 2.99,1.875 3.333,2.063 0.344,0.188 10 true Hold

Using SST, loosen the crankshaft pulley set bolt.

SST
09213-70011  
09330-00021  


b.

Partially install the pulley set bolt to the crankshaft until 2 or 3 threads are engaged.


c.
U153048E01
0.273,3.024 0.608,3.192 0.335,0.169 10 Turn 0.036,2.42 0.371,2.589 0.335,0.169 10 SST 1.509,2.494 1.844,2.663 0.335,0.169 10 Hold

Using the pulley set bolt and SST, remove the crankshaft pulley.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05010, 09954-05021)


Hide 13521A 4.REMOVE CRANKSHAFT TIMING GEAR KEY

a.
A163993

Remove the crankshaft timing gear key from the crankshaft.


Hide 11301C 5.REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

a.
A163774

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.