Home › Engine / Hybrid System › 3UR-FE ENGINE MECHANICAL › CYLINDER HEAD
RM27L0U _51 Engine / Hybrid System _049296 3UR-FE ENGINE MECHANICAL _0235562 CYLINDER HEAD A

3UR-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 11131 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.

·

Take off a cutter gradually to make the intake valve seat smooth.



a.
A145575

Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification.


b.
A380013E01
2.802,0.063 3.042,0.24 0.24,0.177 10 false 60° 3.052,0.302 3.292,0.479 0.24,0.177 10 false 45° 3.219,0.563 3.427,0.74 0.208,0.177 10 false 30° 2.708,1.74 3.146,1.969 0.438,0.229 10 false Width

Using 30° and 60° cutters, correct the valve seat so that the valve contacts the entire circumference of the seat. The contact should be in the center of the valve seat, and the valve seat width should be maintained within the specified range around the entire circumference of the seat.

Standard width:

1.1 to 1.5 mm (0.0433 to 0.0591 in.)



c.

Hand-lap the valve and valve seat with an abrasive compound.


d.

Check the valve seating position.


Hide 11135 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.

·

Take off a cutter gradually to make the exhaust valve seat smooth.



a.
A145576

Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification.


b.
A124255E02
2.568,0 2.809,0.160 0.241,0.160 10 60° 2.943,0.105 3.184,0.266 0.241,0.160 10 45° 3.14,0.382 3.381,0.543 0.241,0.160 10 30° 2.831,1.726 3.258,1.909 0.427,0.183 10 Width

Using 30° and 60° cutters, correct the valve seat so that the valve contacts the entire circumference of the seat. The contact should be in the center of the valve seat, and the valve seat width should be maintained within the specified range around the entire circumference of the seat.

Standard width:

1.1 to 1.5 mm (0.0433 to 0.0591 in.)



c.

Hand-lap the valve and valve seat with an abrasive compound.


d.

Check the valve seating position.