Perform "Inspection After Repair" after replacing the fuel injector assembly.
See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
23250
1.INSTALL FUEL INJECTOR ASSEMBLY
Perform "Inspection After Repair" after replacing the fuel injector assembly.
See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Apply gasoline or spindle oil to a new O-ring and install it to the injector.
Make sure that there is no damage or foreign matter in the groove of the injector when installing the O-ring.
Connect the injector connector.
Install the injector to the fuel delivery pipe as shown in the illustration.
Make sure that there are no scratches or foreign matter in or around the hole of the fuel delivery pipe.
When installing the injector, be careful not to damage the O-ring.
Attach the part of the injector labeled B between the parts of the fuel delivery pipe labeled A.
Check that each injector is installed to the fuel delivery pipe facing the direction shown in the illustration.
23808
2.INSTALL NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY
Install the 2 spacers and 4 insulators to the cylinder head LH.
Install the fuel delivery pipe (with injectors) to the cylinder head LH.
Install the 2 bolts.
Make sure that the part of the injector labeled B is between the parts of the fuel delivery pipe labeled A.
Connect the No. 7 wire harness connector.
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
23807
4.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
Install the 2 spacers and 4 insulators to the cylinder head RH.
Install the fuel delivery pipe (with injectors) to the cylinder head RH.
Install the 2 bolts.
Make sure that the part of the injector labeled B is between the parts of the fuel delivery pipe labeled A.
12613
5.INSTALL NO. 3 ENGINE COVER
12263
6.CONNECT NO. 3 VENTILATION HOSE
Connect the No. 6 wire harness connector.
Connect the No. 3 ventilation hose.
23801P
7.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Connect the No. 1 fuel pipe to the No. 2 fuel delivery pipe (for quick type B) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Attach the clamp.
23901
8.CONNECT FUEL TUBE SUB-ASSEMBLY
Connect the fuel tube to the No. 2 fuel delivery pipe (for quick type A) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the fuel tube to the fuel delivery pipe (for quick type A) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
23902
9.CONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Connect the No. 2 fuel tube to the fuel pressure regulator (for quick type A) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
17880
10.INSTALL AIR CLEANER HOSE ASSEMBLY
11.INSPECT FOR FUEL LEAK
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Do not start the engine.
Turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.
11209
12.INSTALL V-BANK COVER