Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.DISCHARGE FUEL SYSTEM PRESSURE
Discharge the fuel system pressure (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
11209
2.REMOVE V-BANK COVER
17880
3.REMOVE AIR CLEANER HOSE ASSEMBLY
23902
4.DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Disconnect the No. 2 fuel tube from the fuel pressure regulator (for quick type A) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
23901
5.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Disconnect the fuel tube from the fuel delivery pipe (for quick type A) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Disconnect the fuel tube from the No. 2 fuel delivery pipe (for quick type A) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
23801P
6.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Detach the clamp.
Disconnect the No. 1 fuel pipe sub-assembly from the No. 2 fuel delivery pipe sub-assembly (for quick type B) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
12263
7.DISCONNECT NO. 3 VENTILATION HOSE
Disconnect the No. 3 ventilation hose and No. 6 wire harness connector.
12613
8.REMOVE NO. 3 ENGINE COVER
23807
9.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Remove the 2 bolts and fuel delivery pipe.
When removing the delivery pipe, hold the pipe by both ends and pull it straight upward.
Remove the 2 spacers and 4 insulators from the cylinder head RH.
12601B
10.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
23808
11.REMOVE NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY
Disconnect the No. 7 wire harness connector.
Remove the 2 bolts and No. 2 fuel delivery pipe.
When removing the delivery pipe, hold the pipe by both ends and pull it straight upward.
Remove the 2 spacers and 4 insulators from the cylinder head LH.
23250
12.REMOVE FUEL INJECTOR ASSEMBLY
Remove the fuel injector from the fuel delivery pipe, and then disconnect the injector connector.
For reinstallation, attach a tag or label to the injector shaft.
Remove the O-ring from the fuel injector.