Home › Engine / Hybrid System › 3UR-FBE FUEL › FUEL PUMP
RM27L0U _51 Engine / Hybrid System _049297 3UR-FBE FUEL _0235571 FUEL PUMP G

3UR-FBE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL PUMP

A196284E01
1.82,0.652 1.957,0.817 0.137,0.165 10 4 0.142,0.726 0.280,0.891 0.137,0.165 10 5 1.206,1.049 1.646,0.748 1.646,0.748 1.764,0.748 false 0.298,0.806 0.482,0.806 0.482,0.806 1.127,1.072 false 0.008,0.005 2.525,0.383 2.517,0.378 10 Component without harness connected: (Fuel Pump)

a.

Inspect the resistance of the fuel pump.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 5 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel suction with pump and gauge tube assembly.



b.

Inspect the operation of the fuel pump.

i.

Connect the battery positive (+) lead to terminal 4 of the connector, and the negative (-) lead to terminal 5. Check that the fuel pump operates.

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.


·

Keep the fuel pump as far away from the battery as possible.


·

Always turn the voltage on and off on the battery side, not the fuel pump side.



If the result is not as specified, replace the fuel suction with pump and gauge tube assembly.