Home › Engine / Hybrid System › 3UR-FBE FUEL › FUEL SENDER GAUGE ASSEMBLY
RM27L0U _51 Engine / Hybrid System _049297 3UR-FBE FUEL _0235574 FUEL SENDER GAUGE ASSEMBLY A

3UR-FBE FUEL  FUEL SENDER GAUGE ASSEMBLY  REMOVAL  


PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

a.

Remove the fuel suction with pump and gauge tube assembly (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL PUMP>REMOVAL).


Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A194625E02
0.583,1 0.583,0.75 0.583,0.75 0.948,0.375 false 0.094,1.042 0.948,1.51 0.854,0.469 10 false Fuel Suction Plate

Disconnect the connector from the fuel suction plate.


b.
A194626

Using a screwdriver, remove the cap from the connector.

HINT:

Tape the screwdriver tip before use.



c.
A194627

Detach the 2 claws and remove the cover from the connector.


d.
A194660E02
0.948,1.156 0.948,1.635 true 1.583,1.156 1.583,1.625 1.583,1.625 0.615,1.625 true 0.313,1.531 0.635,1.729 0.323,0.198 10 false Tab

As shown in the illustration, unlatch the tabs of the 2 terminals and pull out the 2 wires (blue) from the connector.


e.
A201437

Detach the 2 claws and disconnect the wire harness.


f.
A201438E01
3.04,0.968 3.341,1.165 0.302,0.198 10 Tab 1.827,1.587 2.812,1.056 2.812,1.056 2.986,1.056 false

Push the tab to release the lock of the fuel sender gauge, and slide the fuel sender gauge to remove it.