1.INSPECT FUEL PRESSURE SWITCHING VALVE
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - Body ground | Always | 10 MΩ or higher |
| 2 - Body ground | ||
| 1 - 2 | 20°C (68°F) | 5 to 10 Ω |
If the result is not as specified, replace the valve.
Inspect the valve operation.
Check that air flows from port A to ports B and C.
Apply battery voltage across the terminals as shown in the illustration.
Keep the valve as far away from the battery as possible.
Always turn the voltage on and off on the battery side, not the valve side.
Check that air flows from port A to port C.
If the result is not as specified, replace the valve.