Home › Engine / Hybrid System › 3UR-FE FUEL › FUEL PUMP
RM27L0U _51 Engine / Hybrid System _049298 3UR-FE FUEL _0235582 FUEL PUMP G

3UR-FE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL PUMP

A158976E05
1.542,2.063 1.323,2.594 1.323,2.594 1.323,2.708 true 1.948,2.063 2.177,2.552 2.177,2.552 2.177,2.667 true 2.135,2.698 2.281,2.896 0.146,0.198 10 false 1 1.292,2.708 1.438,2.906 0.146,0.198 10 false 2 0.083,0.083 2.625,0.5 2.542,0.417 10 false Component without harness connected: (Fuel Pump)

a.

Inspect the resistance of the fuel pump.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel suction with pump and gauge tube assembly.



b.

Inspect the operation of the fuel pump.

i.

Connect the battery positive (+) lead to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.


·

Keep the fuel pump as far away from the battery as possible.


·

Always turn the voltage on and off on the battery side, not the fuel pump side.