Perform "Inspection After Repairs" after replacing the fuel pump (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
1.INSTALL FUEL PUMP
Perform "Inspection After Repairs" after replacing the fuel pump (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
Install the fuel pump harness.
Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
Attach the 5 claws to the claw holes and install the fuel pump and suction plate with filter.
2.INSTALL SUB TANK SUB-ASSEMBLY
Attach the 2 claws to the claw holes and install the sub tank sub-assembly.
Attach the 3 claws to the claw holes.
Connect the fuel tube.
Install the tube part to the sub tank sub-assembly.
Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the sub tank sub-assembly.
Connect the fuel pump connector.
83320
3.INSTALL FUEL SENDER GAUGE
Set the sender gauge to the sub tank sub-assembly. Then slide the sender gauge downward to install it.
Connect the fuel sender gauge connector.