Home › Engine / Hybrid System › 3UR-FBE EMISSION CONTROL › AIR PUMP
RM27L0U _51 Engine / Hybrid System _049299 3UR-FBE EMISSION CONTROL _0235586 AIR PUMP A

3UR-FBE EMISSION CONTROL  AIR PUMP  REMOVAL  


PROCEDURE

Hide 1.SEPARATE FRONT FENDER LINER RH

a.
A184974

Remove the 8 clips, separate the fender liner.


Hide 53736 2.SEPARATE FRONT FENDER APRON SEAL RH

a.
A153461

Using a clip remover, separate the 2 clips and fold back the fender apron seal.


Hide 17342 3.REMOVE NO. 2 AIR INJECTION SYSTEM HOSE

a.
A158592E03
0.021,0.042 3.375,0.417 3.354,0.375 10 true Engine Room Side: 0.094,2.24 0.99,3.5 0.896,1.26 10 true Front Fender RH Inside:

Engine Room Side:

i.

Disconnect the 2 clamps.


ii.

Disconnect the No. 2 air injection system hose.


iii.

Using a clip remover, remove the clamp from the body panel.



b.

Front Fender RH Inside:

i.

Disconnect the clamp.


ii.

Disconnect the No. 2 air injection system hose from the air pump.



Hide 17343 4.REMOVE NO. 3 AIR INJECTION SYSTEM HOSE

a.
A158593E04
0.094,0.063 3.396,0.542 3.302,0.479 10 true Engine Room Side: 0.125,2.292 1.01,3.333 0.885,1.042 10 true Front Fender RH Inside:

Engine Room Side:

i.

Disconnect the clamp and No. 3 air injection system hose.


ii.

Using a clip remover, remove the clamp from the body panel.



b.

Front Fender RH Inside:

i.

Disconnect the No. 3 air injection system hose from the air pump.


ii.

Using a clip remover, remove the clamp from the body panel.



Hide 5.REMOVE AIR PUMP ASSEMBLY WITH BRACKET

a.
A184975

Disconnect the 2 air pump connectors and detach the 3 wire harness claws.


b.
A158659

Remove the 2 bolts, 2 nuts and air pump.


Hide 17621A 6.REMOVE AIR PUMP INLET

a.
A273866E03
2.573,0.135 2.333,0.135 false 1.448,1.771 1.115,0.531 1.115,0.531 1.594,1.115 true 1.406,0.063 2.313,0.229 0.906,0.167 10 false Air Pump Inlet 0.188,0.146 1.042,0.625 0.854,0.479 10 false No. 1 Air Injection System Hose

Remove the 2 bolts, slide the 2 clips off of the No. 1 air injection system hoses, disconnect the hoses and remove the air pump inlet.


Hide 17341 7.DISCONNECT NO. 1 AIR INJECTION SYSTEM HOSE

a.

Disconnect the 2 No. 1 air injection system hoses.


Hide 17610C 8.REMOVE AIR PUMP ASSEMBLY

a.
A153467

Using a clip remover, detach the 2 clamps and remove the 2 air pump assemblies from the bracket.


b.

Disconnect the 6 air pump insulators.