Home › Engine / Hybrid System › 3UR-FBE EMISSION CONTROL › PURGE VALVE
RM27L0U _51 Engine / Hybrid System _049299 3UR-FBE EMISSION CONTROL _0235589 PURGE VALVE G

3UR-FBE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

A148341E03
0.225,1.257 0.377,1.426 0.152,0.169 10 1 1.029,1.257 1.181,1.426 0.152,0.169 10 2 1.727,3.135 1.879,3.304 0.152,0.169 10 1 0.485,2.837 0.637,3.005 0.152,0.169 10 2 2.511,2.008 3.209,2.164 0.698,0.156 10 23 to 26 Ω 2.166,4.021 3.169,4.178 1.004,0.156 10 10 kΩ or higher 1.161,3.386 0.703,2.928 false 1.216,3.406 1.659,3.23 false 0.595,0.772 0.429,1.355 0.429,1.355 0.377,1.355 false 0.758,0.794 0.941,1.349 0.941,1.349 0.996,1.349 false 1.659,3.23 1.703,3.23 false 0.703,2.928 0.629,2.928 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - VSV body ground Always 10 kΩ or higher
2 - VSV body ground 10 kΩ or higher


If the result is not as specified, replace the purge VSV.


b.
A148342E03
2.033,0.12 2.294,0.299 0.261,0.179 10 Air 0.238,1.79 1.212,1.969 0.974,0.179 10 Does not flow 1.364,0.703 1.520,0.883 0.157,0.179 10 E 1.076,1.434 1.233,1.613 0.157,0.179 10 F

Inspect the purge VSV operation.

i.

Check that air does not flow from ports.


ii.
A148343E01
1.666,0.113 1.896,0.269 0.230,0.156 10 Air 0.976,0.843 1.143,0.999 0.167,0.156 10 E 0.874,1.806 1.041,1.962 0.167,0.156 10 F

Apply battery voltage across the terminals.


iii.

Check that air flows from ports.

If operation is not as specified, replace the purge VSV.