Home › Engine / Hybrid System › 3UR-FE EMISSION CONTROL › AIR PUMP
RM27L0U _51 Engine / Hybrid System _049300 3UR-FE EMISSION CONTROL _0235593 AIR PUMP A

3UR-FE EMISSION CONTROL  AIR PUMP  REMOVAL  


PROCEDURE

Hide 1.SEPARATE FRONT FENDER LINER RH

a.
A184974

Remove the 8 clips, separate the fender liner.


Hide 53736 2.SEPARATE FRONT FENDER APRON SEAL RH

a.
A153461

Using a clip remover, separate the 2 clips and fold back the fender apron seal.


Hide 17342 3.REMOVE NO. 2 AIR INJECTION SYSTEM HOSE

a.
A158592E03
0.021,0.042 3.375,0.417 3.354,0.375 10 true Engine Room Side: 0.094,2.24 0.99,3.5 0.896,1.26 10 true Front Fender RH Inside:

Engine Room Side:

i.

Disconnect the 2 clamps.


ii.

Disconnect the No. 2 air injection system hose.


iii.

Using a clip remover, remove the clamp from the body panel.



b.

Front Fender RH Inside:

i.

Disconnect the clamp.


ii.

Disconnect the No. 2 air injection system hose from the air pump.



Hide 17343 4.REMOVE NO. 3 AIR INJECTION SYSTEM HOSE

a.
A158593E04
0.094,0.063 3.396,0.542 3.302,0.479 10 true Engine Room Side: 0.125,2.292 1.01,3.333 0.885,1.042 10 true Front Fender RH Inside:

Engine Room Side:

i.

Disconnect the clamp and No. 3 air injection system hose.


ii.

Using a clip remover, remove the clamp from the body panel.



b.

Front Fender RH Inside:

i.

Disconnect the No. 3 air injection system hose from the air pump.


ii.

Using a clip remover, remove the clamp from the body panel.



Hide 5.REMOVE AIR PUMP ASSEMBLY WITH BRACKET

a.
A184975

Disconnect the 2 air pump connectors and detach the 3 wire harness claws.


b.
A158659

Remove the 2 bolts, 2 nuts and air pump.


Hide 17621A 6.REMOVE AIR PUMP INLET

a.
A273866E01
1.209,0.047 2.116,0.213 0.908,0.166 10 Air Pump Inlet 2.575,0.134 2.331,0.134 false 0.027,0.017 0.876,0.490 0.849,0.474 10 No. 1 Air Injection System Hose 1.453,1.766 1.112,0.527 1.112,0.527 1.597,1.117 false

Remove the 2 bolts, slide the 2 clips off of the No. 1 air injection system hoses, disconnect the hoses and remove the air pump inlet.


Hide 17341 7.DISCONNECT NO. 1 AIR INJECTION SYSTEM HOSE

a.

Disconnect the 2 No. 1 air injection system hoses.


Hide 17610C 8.REMOVE AIR PUMP ASSEMBLY

a.
A153467

Using a clip remover, detach the 2 clamps and remove the 2 air pump assemblies from the bracket.


b.

Disconnect the 6 air pump insulators.