Home › Engine / Hybrid System › 3UR-FBE COOLING › THERMOSTAT
RM27L0U _51 Engine / Hybrid System _049303 3UR-FBE COOLING _0235614 THERMOSTAT A

3UR-FBE COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.


PROCEDURE

Hide 17343 4.DISCONNECT NO. 3 AIR INJECTION SYSTEM HOSE

a.
A183217

Disconnect the No. 3 air injection hose.


Hide 17342 5.DISCONNECT NO. 2 AIR INJECTION SYSTEM HOSE

a.
A183219

Disconnect the connector and separate the wire harness clamp.


b.

Disconnect the No. 2 air injection hose.


Hide 17303 6.SEPARATE AIR PIPE SUB-ASSEMBLY

a.
A183221

Disconnect the connector and separate the 2 clamps and wire harness.


b.

Remove bolt and separate the air pipe.


Hide 16572 7.DISCONNECT OUTLET RADIATOR HOSE

Hide 16281F 8.DISCONNECT NO. 5 WATER BY-PASS HOSE

a.
A183224

Disconnect the No. 5 water by-pass hose.


Hide 16031 9.REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

a.
A151841

Remove the 3 nuts, water inlet with thermostat and gasket.