Home › Drivetrain › AB60E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE
RM27L0U _52 Drivetrain _049311 AB60E AUTOMATIC TRANSMISSION / TRANSAXLE _0235667 TRANSMISSION CONTROL CABLE A

AB60E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 33820B 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C157286

Insert the floor shift transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.
U152174E01
2.421,0.797 2.428,0.803 false 2.323,0.898 2.337,0.91 false

Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip.


c.
U152184E01
0.799,0.111 1.615,0.309 0.815,0.198 10 Ridged Side 2.236,0.583 1.788,0.256 false

Connect the control cable end to the shift lever.

NOTICE:

Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable end's ridged side is facing upward.



d.

Move the shift lever to N.


e.
C155873E04
1.906,0.052 2.052,0.219 0.146,0.167 10 false N 1.021,0.302 1.146,0.469 0.125,0.167 10 false P 1.573,0.292 1.719,0.458 0.146,0.167 10 false R

Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.


f.
U152182E03
2.563,0.74 1.427,0.979 true 0.917,0.885 1.448,1.052 0.531,0.167 10 false Bracket 0.958,0.188 2.073,0.385 1.115,0.198 10 true Inside of Vehicle

Connect the control cable with a new clip and the nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:

When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the inside of the vehicle.



g.
C157285

Connect the transmission control cable support with the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 2.INSTALL FRONT CONSOLE BOX ASSEMBLY

a.

Remove the front console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION).