85903
1.INSTALL SHIFT LOCK CONTROL ECU
Engage the 3 claws, and install the shift lock control ECU.
Connect the shift lock solenoid connector.
35974
2.INSTALL LOWER POSITION INDICATOR HOUSING
Engage the 6 claws, and install the lower position indicator housing.
33563
3.INSTALL SHIFT LOCK RELEASE BUTTON
Engage the 2 claws, and install the shift lock release spring and shift lock release button.
35976
4.INSTALL NO. 2 POSITION INDICATOR SLIDE COVER
Install the No. 2 position indicator slide cover to the position indicator slide cover.
35975
5.INSTALL POSITION INDICATOR SLIDE COVER
Install the position indicator slide cover with the No. 2 position indicator slide cover.
Install the position indicator slide cover so that its mark faces the vehicle front.
35970F
6.INSTALL POSITION INDICATOR HOUSING ASSEMBLY
Engage the 4 claws, and install the position indicator housing.
35906
7.INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY
Align the wire with the key part of the position indicator housing lower, and install the wire. Then rotate the wire clockwise until it locks.
Securely connect the 2 wire terminals to terminal 4 (ILL+) and 8 (ILL-) of the transmission control switch connector. Then push the connector housing retainer to lock it.
Check the indicator light wire harness as shown in the illustration.