| Malfunction Item | Fail-Safe Operation | Indicator Light | Fail-Safe Deactivation Condition |
|---|---|---|---|
| 4WD control ECU malfunction | ·
2WD to 4WD HIGH switching is not possible ·
4WD HIGH to 4WD LOW switching is not possible ·
Changing center differential from free to lock and lock to free is not possible |
4HI indicator light, 4LO indicator light and CENTER DIFF. Indicator light blink at 0.2 seconds intervals | Ignition switch off |
| Wheel speed signal malfunction | ·
2WD to 4WD HIGH switching is not possible ·
4WD HIGH to 4WD LOW switching is not possible ·
Changing center differential from free to lock is not possible |
4HI indicator light blinks at 0.2 seconds intervals. The 4LO and CENTER DIFF. indicator lights may also blink at 0.2 seconds intervals | ·
When signal returns to normal ·
When the 4WD control switch and transfer shift actuator positions are the same ·
Ignition switch off |
| A/T shift position signal malfunction | 4WD HIGH to 4WD LOW switching is not possible | 4LO indicator light blinks at 0.2 seconds intervals | ·
When signal returns to normal ·
When the 4WD control switch and transfer shift actuator positions are the same ·
Ignition switch off |
| Engine speed signal malfunction | 4WD HIGH to 4WD LOW switching is not possible | ||
| A.D.D. actuator limit switch malfunction | ·
2WD to 4WD HIGH switching is not possible ·
4WD HIGH to 4WD LOW switching is not possible ·
During cruise control AUTO driving, cruise control system is turned OFF ·
Changing center differential from free to lock and lock to free is not possible |
4HI indicator light blinks at 0.2 seconds intervals | Ignition switch off |
| Multi mode transfer shift actuator limit switch malfunction | ·
2WD to 4WD HIGH switching is not possible ·
4WD HIGH to 4WD LOW switching is not possible ·
During cruise control AUTO driving, cruise control system is turned OFF ·
Changing center differential from free to lock and lock to free is not possible |
CENTER DIFF. indicator light blinks at 0.2 seconds intervals | |
| High-low transfer shift actuator limit switch malfunction | ·
2WD to 4WD HIGH switching is not possible ·
4WD HIGH to 4WD LOW switching is not possible ·
Changing center differential from free to lock and lock to free is not possible |
4LO indicator light blinks at 0.2 seconds intervals |
When the switching operation is performed during cruise control AUTO driving, if the switch completion does not occur 5 seconds after the switching operation, the cruise control system is turned off.