Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM27L0U _52 Drivetrain _049313 DRIVE SHAFT / PROPELLER SHAFT _0235681 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 43420 1.INSTALL FRONT DRIVE SHAFT ASSEMBLY

a.

Coat the spline of the inboard joint shaft assembly with gear oil.


b.
C353597

Align the shaft splines and install the drive shaft with a brass bar and hammer.

NOTICE:

Be careful not to damage the differential oil seal, inboard joint boot and drive shaft dust cover.


HINT:
·

Set the inboard joint shaft snap ring with the opening side facing downward.

·

Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when driving it.




Hide 2.INSTALL STEERING KNUCKLE ASSEMBLY

a.

Install the steering knuckle assembly (See page Drivetrain>AXLE AND DIFFERENTIAL>STEERING KNUCKLE>INSTALLATION).


Hide 4.INSPECT FOR FRONT DIFFERENTIAL OIL LEAK