Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM27L0U _52 Drivetrain _049313 DRIVE SHAFT / PROPELLER SHAFT _0235684 FRONT PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 04371G 3.REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER

a.
C158560E02
2.149,0.063 2.930,0.209 0.781,0.146 10 Matchmarks 1.397,0.624 2.13,0.152 2.13,0.152 1.639,0.734 false

Place matchmarks on the universal joint flange yoke and propeller shaft's universal joint flange yoke.


b.
C158561

Using a brass bar and hammer, slightly tap in the universal joint spider bearing.


c.

Using needle-nose pliers, remove the 4 hole snap rings from the grooves.


d.
F015025E24
1.229,0.74 0.354,0.74 false 2.479,1.156 2.156,1.406 false 0.052,0.656 0.354,0.823 0.302,0.167 10 false SST 2.052,1.344 2.177,1.552 0.125,0.208 10 true A

Using SST, push out the universal joint spider bearing from the shaft's universal joint flange yoke.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



e.
F044192E16
2.406,0.708 2.885,1.042 false 2.594,1.063 3.344,1.427 0.75,0.365 10 false Hammering Point

Clamp the universal joint spider bearing in a vise and tap off the propeller shaft with a hammer.

NOTICE:

Do not tap the shaft tube.


HINT:

Use the same removal procedure for the universal joint spider bearing on the opposite side.



f.

Install the 2 removed universal joint spider bearing to the universal joint spider.


g.
F015030E20
2.563,1.063 2.177,1.313 false 0.646,1.115 0.938,1.115 false 2.052,1.24 2.167,1.375 0.115,0.135 10 false A 0.292,1.042 0.594,1.25 0.302,0.208 10 false SST

Using SST, push the universal joint spider bearing out of the universal joint flange yoke.

SST
09332-25010  

HINT:

Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



h.
C158562E03
1.469,0.229 1.854,0.229 false 1.854,0.229 2.385,0.583 false 0.385,0.146 1.531,0.375 1.146,0.229 10 false Hammering Point

Clamp the universal joint spider bearing in a vise and tap off the universal joint flange yoke with a hammer.


i.

Remove the universal joint spider.

HINT:

Use the same removal procedure for the universal joint spider on the opposite side.