Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY
RM27L0U _52 Drivetrain _049313 DRIVE SHAFT / PROPELLER SHAFT _0235684 FRONT PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY  REASSEMBLY  


PROCEDURE

Hide 04371G 1.INSTALL FRONT PROPELLER SHAFT UNIVERSAL J0INT SPIDER

a.
C134387

Apply MP grease to a new universal joint spider and universal joint spider bearings.

NOTICE:

Be careful not to apply too much grease.



b.
C159977E01
1.407,0.904 1.525,1.065 0.118,0.162 10 A 1.666,0.913 1.795,1.071 0.130,0.158 10 B

Measure dimension A between the snap ring grooves.


c.

Install the universal joint spider bearing into the universal joint spider and measure dimension B.

HINT:

When measuring dimension B, clamp the universal joint spider and universal joint spider bearing in a vise to hold them together.



d.
G038874

Select hole snap rings of the correct thickness to make dimensions A and B the same.

Hole Snap Ring Thickness:
Color Thickness mm (in.)
Green 1.384 mm (0.0545 in.)
Red 1.435 mm (0.0565 in.)
Black 1.486 mm (0.0585 in.)
Copper 1.511 mm (0.0595 in.)
Silver 1.537 mm (0.0605 in.)
Yellow 1.588 mm (0.0625 in.)
Blue 1.638 mm (0.0645 in.)


NOTICE:
·

Use new snap rings.

·

If possible, use snap rings of the same thickness for both edges.




e.
C353598E01
1.094,0.958 1.094,0.271 1.094,0.271 0.771,0.271 false 0.469,0.198 0.927,0.396 0.458,0.198 10 false SST

Insert the universal joint spider into the universal joint flange yoke, and then using SST, press in the universal joint spider bearing into the snap ring groove.

SST
09332-25010  

NOTICE:

When pressing in the universal joint spider bearing, be careful not to damage its lip.


HINT:

Use the same installation procedure for the universal joint spider bearing on the opposite side.



f.
G038875

Using needle-nose pliers, install new hole snap rings into the snap ring grooves of the yoke.


Hide 2.INSPECT PROPELLER SHAFT GREASE FITTING DIRECTION

HINT:

When replacing a spider bearing, be sure that the grease fitting hole is facing the direction shown in the illustration.


U153600E01
1.579,0.176 2.302,0.353 0.723,0.177 10 Front Side 6.442,0.842 6.608,1.021 0.165,0.179 10 A 6.244,1.946 6.752,2.125 0.508,0.179 10 View A 1.567,1.664 2.038,1.824 0.471,0.161 10 No. 1 4.334,0.267 4.805,0.428 0.471,0.161 10 No. 2 1.541,1.742 1.096,0.961 false 4.715,0.342 5.1,0.862 false 4.782,1.633 5.253,1.794 0.471,0.161 10 No. 2 4.852,2.378 5.323,2.539 0.471,0.161 10 No. 1